GSM-WARE

i have tested on K618, reball ic flash and make jumper cable to connect test point

first make test point cable, testpoint is +3.3 voltage, connected to specific pin.
we suggesting to use +3.3v battery
(battery ground MUST be connected with phone’s GROUND)

here the picture ( u can use original setool cable)

SETool Test Point

usage:
1. go to emptyboard fill & repair.
2. select any db2020 model.
3. press “TP STAGE #1″. read instructions and execute them.
4. press “TP STAGE #2″. read instructions and execute them.
5. phone is BROWN now.
6. staying on “emptyboard fill and repair” write correct gdfs_in_ssw format.
7. if flashing went fine, flash db2020 erom with needed CID.
8. phone now retail and repaired. fullflash phone as usual.

after SETOOL2 db2020 testpoint procedure phone FULLY working in “alternative security bypass” mode without ANY restrictions.