GSM-WARE » setool http://gsm-ware.com GSM Hardware & Software Information Fri, 02 Jul 2010 08:03:25 +0000 en hourly 1 http://wordpress.org/?v=3.0 SETOOL DB2020 Cross Flasing http://gsm-ware.com/2008/12/25/setool-db2020-cross-flasing/ http://gsm-ware.com/2008/12/25/setool-db2020-cross-flasing/#comments Thu, 25 Dec 2008 06:18:21 +0000 admin http://gsm-ware.com/2008/12/25/setool-db2020-cross-flasing/ its used to flash DB2020 using diferent CID on phone and flash file
-use USB Interface
-on setting tick SIGNED MODE, ENABLE ALTERNATIVE SECURITY BYPASS, COMPLETE PHONE AFTER FLASH
-load Flash file
-klik FLASH and folow instruction on log window

]]> http://gsm-ware.com/2008/12/25/setool-db2020-cross-flasing/feed/ 2 DB2020 GDFS Repair using SETOOL http://gsm-ware.com/2008/07/22/db2020-gdfs-repair-using-setool/ http://gsm-ware.com/2008/07/22/db2020-gdfs-repair-using-setool/#comments Tue, 22 Jul 2008 08:33:01 +0000 admin http://gsm-ware.com/?p=15 i have tested on K618, reball ic flash and make jumper cable to connect test point

first make test point cable, testpoint is +3.3 voltage, connected to specific pin.
we suggesting to use +3.3v battery
(battery ground MUST be connected with phone’s GROUND)

here the picture ( u can use original setool cable)

SETool Test Point

SETool Test Point

usage:
1. go to emptyboard fill & repair.
2. select any db2020 model.
3. press “TP STAGE #1″. read instructions and execute them.
4. press “TP STAGE #2″. read instructions and execute them.
5. phone is BROWN now.
6. staying on “emptyboard fill and repair” write correct gdfs_in_ssw format.
7. if flashing went fine, flash db2020 erom with needed CID.
8. phone now retail and repaired. fullflash phone as usual.

after SETOOL2 db2020 testpoint procedure phone FULLY working in “alternative security bypass” mode without ANY restrictions.

]]> http://gsm-ware.com/2008/07/22/db2020-gdfs-repair-using-setool/feed/ 2